Sanyo PDG-DXL2000 Manual do Proprietário Página 69

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 142
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 68
69
Appendix
Troubleshooting
Before calling your dealer or service center for assistance, check the items below once again.
– Make sure you have properly connected the projector to peripheral equipment as described on pages 16-18.
– Make sure all equipment is connected to AC outlet and the power is turned on.
– When the projector does not project an image from the connected computer, restart the computer.
Problem Solutions Pages
Power
No power
Q
Plug the power cord of the projector into the AC outlet.
Q
See if the POWER indicator lights red.
Q
Wait until the POWER indicator stops blinking to turn on the
projector again. The projector can be turned on after the
POWER indicator turns red.
20
Q
Check the WARNING indicator. If the WARNING TEMP.
indicator lights red, projector can not be turned on.
64
Q
Check the projection lamp. 67
Q
Unlock the Key lock function for the projector. 59
PIN code dialog box appears at
start-up.
Q
PIN code lock is being set. Enter a PIN code (the “1234” or
numbers you have set.)
21,
59-60
Opening display
The initial display is not shown.
Q
Make sure Off or Countdown off are not chosen at display
function.
53
The initial display is not same
as the default set.
Q
Make sure User or Off are not chosen at Logo (select)
function.
53
Input signal switches automati-
cally. (or does not switch auto-
matically)
Q
Make sure Input search function is adjusted properly. 51
An icon other than Input mode
or Lamp mode icon appears
Q
That is the Filter warning icon or the Lamp replacement icon. 62, 67
Image
No image
Q
Check the connection between your computer or video
equipment and the projector.
16-18
Q
See if the input signal is correctly output from your computer.
Some laptop computers may need to change the setting for
monitor output when connecting to a projector. See your
computer’s instruction manual for the setting.
Q
It takes about 30 seconds to display an image after turning on
the projector.
20
Q
Check the Input signal, color system, video system or
computer system mode.
Q
Make sure the temperature is not out of the specified
2SHUDWLQJ7HPSHUDWXUHÛ)±Û)>Û&±Û&@
Q
When No Show is operating, the image can not be displayed.
Press the NO SHOW button or any other button on the remote
control.
Image is Left/Right reversed.
Q
Check the Ceiling/Rear function. 40, 47
Image is Top/Bottom reversed.
Q
Check the Ceiling function. 40, 47
Vista de página 68
1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 141 142

Comentários a estes Manuais

Sem comentários