Sanyo VCC-5984 Manual do Utilizador

INSTRUCTION MANUALVCC-5984COLOR CCD CAMERA About this manualBefore installing and using the camera, please read this manualcarefully. Be sure to keep

MOUNTING THE LENSRewiring the lens cable in the lens iris plug1Prepare the lens cable.Cut the cable at the plug, then remove approx. 8 mm of the cable

CONNECTIONSBasic connection for monitoring or recordingThe peripheral devices (VCR, monitor, lens, etc.), AC adaptorand cables are sold separately.1Ma

SETTINGSThe illustration shows the factory default settings for the switches in the camera setup section.The camera settings are described on the assu

SETTINGSElectronic shutter settings and electronic irissettings 1When all of these switches are down, electronic shutter (1/60 sec orauto iris setting

SETTINGSBacklight compensation setting 45This camera has two different backlightcompensation functions: Normally backlightcompensation switch 6 (MULT)

SETTINGSWhite balance adjustment 6Normally the switch 8 (WB) is set to the down (ATW: auto whitebalance) position and the white balance is adjusted au

SETTINGSLens iris adjustment 9If using a DC type auto-iris lens, you will need to set the LEVEL(VR301) volume when shooting in the conditions describe

TROUBLESHOOTINGBefore taking the camera for repairs, please check below to make sure that the camera is used correctly. If it still does not perform c

SPECIFICATIONSCamera:Scanning system :NTSC standard TV system(525 TV lines, 30 frames/sec.)Interlace :PLL 2:1 interlaceImage device :1/3 inch solid st

SANYO INDUSTRIAL VIDEOCOLOR VIDEO CAMERA LIMITED WARRANTYOBLIGATIONSIn order to obtain warranty service, the product must be delivered to and picked u

Depending on the conditions of use, installation and environment,please be sure to make the appropriate settings and adjustments. If youneed help with

Printed on recycled paper1AC6P1P2624--L53H4/US2(0103KPS-CZ)SANYO Electric Co., Ltd.Printed in JapanL53H4/US2 (VCC-5984) GB 2003, 1, 7

INFORMATION TO USERSafety GuardTHIS SYMBOL INDICATES THAT THERE AREIMPORTANT OPERATING AND MAINTENANCEINSTRUCTIONS IN THE LITERATUREACCOMPANYING THIS

PRECAUTIONSIn case of problemDo not use the camera if smoke or a strange odour comes from theunit, or if it seems not to function correctly. Disconnec

PARTS NAMES1Video output connector (VIDEO OUT: BNC type)Connect this connector to a device such as a VCR or monitor with a VIDEO IN connector.2Power i

PARTS NAMES5Lens mount capThe cap is installed to protect the lens mount section.Remove the lens mount cap before installing a lens (sold separately).

PARTS NAMES9Lens iris output connector (LENS)This 4-pin connector is used to send the DC control signal and power supply to an auto-iris type lens.FCa

CONCERNING AUTO-IRIS LENSESDC type auto-iris lensA lens without amplifier circuit that operates only on a DC power source. In general, this type of le

MOUNTING THE LENSPlease use a DC type auto-iris lens (sold separately).Check the lens mountDo not use a lens if the length “L” is more than 5 mm. That